![]() ![]() At some point, around 5V, a dim red light started to appear, and as I went up with the voltage knobs, I suddenly got green and then blue. I connected that pin to the power supply, and then started from a low voltage, limiting the current to 80mA, and slowly raised the voltage limit. I figured out that if I wanted actual light output, I will probably need to supply some power to the “V+” pin, as it is the one that goes to the LED board. It seemed like it everything worked, save one thing: there was no light! Let There Be Light! Not only I could see it, I could even connect to it with both the official app as well as the app I built for the AngularConnect workshop and send some commands.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |